DETAILED DESCRIPTION
The NACA droops and wing tip extensions attach to the outer section of the wing. They help stabilize the Raptor by manipulating the stock airfoil to produce added lift and increased wing area for lower wing loading. After your training is complete, remove the droops and extensions to transform the trainer into a jet-like fighter. Droops and application tape are supplied but not installed. Flaps can be set specifically for Basic Training in a position that provides speed control and added lift. When you’re ready to move up, add two servos and upgrade to functioning flaps with mid and full positions.
Field assembly has never been easier or simpler. The quick-release hatches are spring-loaded to allow easy access to your electronics and fuel tank. A prepainted pilot figure comes installed inside the front hatch. The wing and tail sections bolt and slide together easily for convenient transport and storage. You will need a 3/32 Allen wrench (included) or ball driver to attach the tail.
This one-of-a-kind jet-like fighter is available in this stunning high-visibility red and white color scheme or in stealth gray (HAN4385) color scheme, giving pilots at all experience levels the opportunity to fly the Raptor. From training to high-speed loops, rolls and low passes, make your tracks in the sky with the F-22 Raptor.
Lockheed Martin®, F-22 Raptor™, associated emblems and logos, and body designs of vehicles are either registered trademarks or trademarks of Lockheed Martin Corporation in the USA and/or other jurisdictions, used under license by Horizon Hobby, Inc.
- Progressive design allows smooth advancement
- Included NACA droops prevent spins and tip stalls
- 3-position flap system and wing tip extensions for speed control and additional lift
- Prepainted pilot figure installed in cockpit
- Precision laser cut parts and the latest assembly techniques
- Removable plug-in wings for simple field assembly, easy transportation and storage
- Easy access canopy and main hatch
- Covered in exclusive Hangar 9® UltraCote®
You will need...
.46 - .52 2-cycle Glow Engine: Evolution .46NT (EVOE0460) or .52NX (EVOE0520
4-channel radio system (minimum) with reciever: Spektrum DX7 (SPM2710) or JR 6-channel SX600 (JSP16000)
ST47 Servo (JSP20050) (5) or equivalent
6-inch Servo Lead Extension (JRPA095) (2)
Long Servo Arm (JRPA212) (2)
Y-harness (JSP98020)
Receiver Battery (JSP91010)
Receiver (JSP30060)
Switch Harness (JSP98010)
2- or 3-bladed Propeller: (EVOE100P)
Optional/Additional Radio Equipment for Flap Installation:
5-channel radio system (minimum) with receiver
Long Servo Arm (JRPA212) (2)
ST47 Servo (JSP20050)
ST47 Reverse Servo (JSP20050R)
Y-Harness (JSP98020)
See more: Products
